JRC JR-8600 User Manual

4-62
4.12.8 Initialising sensors
Initialise sensors.
Set a general position and current date and time (UTC) of the sensor.
For a processor with two sensors connected, the sensors must be set individually.
In this example, sensor 1 is connected. The same procedure is applied for setting sensor 2 also.
Procedure
1. Enter a password by referencing "4.2.11. Entering a password with CODE INPUT”.
Password: 1650
2.
  
4.12.9 Setting a DGPS correction mode
A DGPS correction mode can be selected.
To perform DGPS correction, set the positioning system to “GPS”.
In multi-GNSS mode, DGPS positioning cannot be performed.
If a correction mode is set in multi-GNSS mode, the positioning system is automatically set to
“GPS”.
JLR-4350 does not support DGLONASS and DBeiDou. Correction data of QZSS cannot be
received.
For a processor with two sensors connected, the sensors must be set individually.
In this example, sensor 1 is connected. The same procedure is applied for setting sensor 2 also.
Procedure
1. Enter a password by referencing "4.2.11. Entering a password with CODE INPUT”.
Password: 1650
2.
  
INIT Description
QUADRANT Select North latitude/South latitude/East latitude/West latitude of the sensor
position.
LAT Enter a
g
eneral position
(
latitude
)
of the sensor.
LON Enter a
g
eneral position
(
lon
g
itude
)
of the sensor.
ANT HEIGHT Enter a general position (height) of the sensor.
For 2-dimensional position fixin
g
, this hei
g
ht is used.
YEAR Enter the current
y
ear
(
UTC
)
.
MONTH Enter the current month
(
UTC
)
.
DAY Enter the current da
y
(
UTC
)
.
HOUR Enter the current hour
(
UTC
)
.
MINUTE Enter the current minute
(
UTC
)
.

JRC JR-8600 Specifications

General

Brand	JRC
Model	JR-8600
Category	GPS
Language	English