4-9
2) Error startup 1
The message that is shown below may be displayed in the receiver diagnosis.
This message is displayed when the setting values do not match between the processor and
the receiver due to the equipment replacement or other reason.
In this case, select one of the following items.
[USE SENSOR CONFIG.]: The setting value of the processor is rewritten so as to
match the setting value of the receiver.
[USE PROCESSOR CONFIG.]: The setting value of the receiver is rewritten so as to match
the setting value of the processor.
3) Error startup 2
If any one of the diagnosis results is ‘NG’, the result will be displayed continuously.
The screen is not switched to the normal screen unless “SKIP” is tapped.
4.2.3 Turning off the power of the unit
When the Power key is pressed, the following message is displayed. When “YES” is selected, the
power is turned off.
When there is any error (NG), contact Nippon Signal or your distributor.
Attention
Even if the message is displayed, the power of the display is turned off forcibly if the
Power key is held down for about 8 seconds. In this case, the power of the display is
turned off, but the processor operates continuously.
When the display unit is energised even if the power is Off, the LED of the Power key
is lit.
Memo
POWER OFF
ARE YOU SURE
To Next Page
Loading...
Need help?
General
