4-67
4.13.3 Setting magnetic correction
Magnetic correction can be applied to the route that was obtained from GPS.
Procedure
1. Enter a password by referencing "4.2.11. Entering a password with CODE INPUT”.
Password: 1650
2.
3. Confirm the setting with .
4.13.4 Setting LORAN A/C
A position can be displayed or set with a time difference.
When LORAN A/C is set, all the position information is displayed in time difference.
Procedure
1. Enter a password by referencing “4.2.11 Entering a password in CODE INPUT”.
Password: 1650
2.
3. Enter each setting value.
4.
Tap to confirm the setting.
MAG CORR Description
AUTO Performs correction automatically by calculating the correction value from the
GPS position.
MANUAL Performs correction with the correction value that was input.
EAST/WEST: Select East longitude or West longitude.
CORRECTION VALUE: Enter a correction value.
OFF Does not perform correction.
LORAN Description
LORAN A
: Moves to the LORAN A setting screen.
LORAN C
: Moves to the LORAN C setting screen.
OFF Displa
s in the latitude/lon
itude.
LORAN A stations that can be set
1S1,1S2,1S3,1S4,1S6,1L0,1L1,1L4,1L5,2S0,2S1,2S2,2S3,2S4,2S5,2S6,2S7,2H4,2H5, 2H6
LORAN C chains that can be set
4990, 5930, 5970, 5980, 5990, 6730, 6731, 6780, 7001, 7030, 7170, 7270, 7430, 7499, 7930,
7950, 7960, 7970, 7980, 7990, 8000, 8290, 8390, 8830, 8930, 8970, 8990, 9007, 9610, 9930,
9940, 9960, 9970, 9980, 9990
Memo
To Next Page
Loading...
Need help?
General
