4-23
4. Confirm the operation by tapping .
4.4.5 Deleting waypoints
Waypoints registered from numbers 1 to 10000 can be deleted.
Waypoints on the route that is currently executed cannot be deleted.
If a waypoint is on the route that is not being executed is deleted, the waypoint is deleted from
the route also.
Procedure
1.
2. Tap a deletion source. A deletion source submenu is outlined below.
(1) Any input: Enter a waypoint number to be deleted.
(2) Waypoint list: Specify from a waypoint list.
(3) ALL: All the waypoints are deleted.
(1) Any input
Enter a starting point and an ending point of the number of the waypoint to be deleted.
When deleting one point only, enter the same number for a starting point and an ending point.
(2) Waypoint list
When a waypoint list is displayed, select a starting point and an editing point of the waypoints
to be deleted.
When deleting one point only, enter the same number for a starting point and an ending point.
(3) All
All the waypoints are deleted.
3. The range to be deleted and the number of waypoints to be deleted are displayed.
4. Confirm the selection by tapping .
Waypoints can be deleted from a plotting screen. For the editing method, refer to “4.9.10
Displaying symbol information”.
When selecting copy sources with consecutive numbers, numbers that cross over a
boundary such as 10000 or 10512 cannot be selected.
Example) Numbers from 9999 to 10001 or numbers from 10511 to 10513 cannot be
selected.
Memo
To Next Page
Loading...
Need help?
General
