EasyManuals Logo

JRC JR-8600 User Manual

JRC JR-8600
163 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
4-15
4.2.10 List operation
This section shows the list operation method.
The same operation method is applied for a waypoint list, a route list, and an event mark list.
When the list is empty, the following message is displayed.
4.2.11 Entering a password in CODE INPUT
Some setting items are protected by a password to prevent them being changed easily.
If the power is turned off or no operation is performed for five minutes after a password is set, the
password is reset.
To set a password, enter a password again in CODE INPUT.
Procedure
1.
2. Enter a password and confirm it with .
Entered password
Indicated by ****.
Menu level
Page
No. of waypoints registered/total
number of waypoints that can be
registered
Page feed (< >)
Move to the next page.
List content display area
The number input screen is
displayed and control jumps
to the input number.
Jumps to the
previous free
number
Jumps to the next
free number

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JRC JR-8600 and is the answer not in the manual?

JRC JR-8600 Specifications

General IconGeneral
BrandJRC
ModelJR-8600
CategoryGPS
LanguageEnglish

Related product manuals