vi
When connecting the cable attached to the equipment, do not bend it acutely, twist
it, or impart excessive force. Doing so sometimes causes cracks or damage to the
coating, resulting in fire or electrocution.
Do not install the sensor where there is excessive vibration.
Vibration may cause sensor failure.
Do not paint the sensor.
Doing so may result in reception problems.
Do not install the sensor where temperature exceeds 55 degrees Celsius and
there is covered with exhaust gas from funnel. Doing so may result in flood and
cause sensor failure.
The junction box rubber gaskets (25 f Gland side) fit 10mm – 20mm cables.
Install the sensor where there are no obstacles, in order to ensure that GPS signals
can be directly received from satellites without interference or reflection of signals
from surrounding objects.
Whenever possible, select a place with the following characteristics.
If it is difficult to find an ideal site, select a place temporarily and install the equipment. Conduct a test to make
sure that the proper performance can be obtained and then fix the equipment in position. If it is installed at an
improper place, reception accuracy may be impaired.
If occurs bad positioning of such as satellite can not be received, please execute the
master reset of sensor.
There are cases when time lags in the gps navigator and gps compass.
This is not a malfunction due to the delay in the internal processing.
There are cases when time lags in the main display unit and sub display unit.
This is not a malfunction due to the delay in the internal processing.
1. An open space, which allows uniform reception of satellite signals.
2. Far away from any high power transmission antennas.
3. Outside radar beams.
4. Away from the INMARSAT antenna by at least 5 meters and outside
the INMARSAT beam.
5. Away from the antenna of a VHF transmitter and a direction finder
by at least 3 meters.
6. Away from a Magnetic Compass by at least 1 meter.
7. 3 meters or more away from amateur radio antennas.
CAUTION
To Next Page
Loading...
