4-51
(1) Setting the SYSTEM alert
a) Tap .
(2) Setting ARRIVAL/ANCHOR alerts
The alert is issued when the ship arrives at or crossed the arrival circle radius that was set in the
route. If the arrival circle radius is not set in the route, the alert is issued when the ship reaches the
arrival circle radius that is set as the route initial value.
Arrival and cross-track cannot be set concurrently.
a) Tap .
(3) Setting XTD/BOUNDARY alerts
The alert is issued when the ship cross-tracks from or approaches the route width that was set in
the route. When the route width is not set in the route, an alert is issued when the ship cross-tracks
from or enters in the route width that is set as the initial value in the route.
Cross-track and approach cannot be set concurrently.
a) Tap .
Item Description
SET Sets alert notification to ON/OFF.
ON: Notifies the occurrence of an alert.
OFF: Sets alert to OFF.
SOUND Sets the buzzer sound upon the issuance of an alert to ON/OFF.
ON: When an alert is issued, the alert is notified with a buzzer sound.
OFF: Even if an alert is issued, a buzzer sound is not emitted.
Item Description
SET Sets alert notification to ON/OFF.
ARRIVAL: Notifies the waypoint arrival alert.
ANCHOR: Notifies the waypoint cross-track alert.
OFF: Sets the alert to OFF.
SOUND Sets the buzzer sound upon the issuance of an alert to ON/OFF.
ON: When an alert is issued, the alert is notified with a buzzer sound.
OFF: Even if an alert is issued, a buzzer sound is not emitted.
To Next Page
Loading...
Need help?
General
