6 Operation
38 IMAGO F3000 / 10.01
6.4 Automatic operation
In automatic operation, both process screens are presented with all the set-
points that have been defined. All the controllers which have been selected for
the process steps are activated, and the “Automatic” symbol appears at bot-
tom right.
Screen
changeover
6.4.1 Pause program
If this is pressed once, the program run timer is paused, and a coffee-cup
symbol appears in the screen at bottom right.
h Press the key again
The coffee cup disappears, and the program continues to run from the point
where it was interrupted.
H
These screen layouts can be freely arranged in the setup
v Chapter “Screen layout”
To Next Page
Loading...
Need help?
General
