IMAGO F3000 / 10.01 45
6 Operation
6.9.9 Password (config)
The factory-set password is 9200. The password can be defined separately for
the parameter and configuration levels.
v Chapter 7.6.2 “Instrument data”
6.10 MENU parameterization
This includes all the settings that must be made during commissioning and
adapted to suit the system during test running.
6.10.1 Controller parameter sets
8 different parameter sets can be entered here.
v Chapter 7.5.1 “Controller parameters”
The assignment of the parameter sets to the controllers is made during the
definition of the process steps.
v Chapter 7.2 “Process steps”
6.10.2 Limit comparators
Here you can enter the switching action, limits, switching differential, action
and switching status on probe break.
v Chapter 7.5.2 “Limit comparators”
6.10.3 Smoke generator
The settings for operating a smoke generator with a conveyor screw are made
here.
Chapter 7.5.3 “Smoke generator”
6.10.4 Self-optimization
Here you can define which controllers are to be optimized, and which parame-
ter set is to be used to store the parameters which are determined.
Self-optimization can only be initiated on the instrument itself.
6.10.5 Password (parameter)
The factory-set password is 9200. The password can be defined separately for
the parameter and configuration levels.
v Chapter 7.6.2 “Instrument data”
To Next Page
Loading...
Need help?
General
