6 Operation
46 IMAGO F3000 / 10.01
6.11 User data
The settings are not protected by a password, and can be set up individually
by each user.
6.11.1 Contrast
This alters the brightness of the screen.
6.11.2 Display
Here you can define a time after which the screen goes dark, or light up the
screen for a preset length of time.
6.11.3 Instrument data
Instrument data which can be set are: the instrument name at the top of the
screen, local language, date/time and summer-time changeover, and the type
and method of program selection.
6.12 MENU counter
The counter is an operating-hours counter. It is used to record the running time
of external equipment, such as a pump. The counter starts to run when a logic
signal changes state to a logical “1”.
If the counter has reached a preset value, then an output is set. This output
can be used to operate a relay or produce an alarm signal.
6.13 MENU instrument access
Enabling access to the instrument can be understood as follows: the OEM
manufacturer can deliver the equipment to the end user with access enabled
for a fixed period. At the end of this period it is no longer possible to run a pro-
gram, and a password must be used to enable the system again.
To Next Page
Loading...
Need help?
General
