• Synchronised fork carriage rotation through 90° to the right and load handler
traverse to the centre position:
• Press and hold down the key (104) under the "synchronised rotation until forks
are in centre position" symbol (176) until the fork carriage stops rotating.
• Turn the "hydraulic functions" control lever (113) anticlockwise until the
attachment comes to a stop in the middle of the swivel traverse frame.
• Synchronised fork carriage rotation through 90° to the left and load handler
traverse to the centre position:
• Press and hold down the key (104) under the "synchronised rotation until forks
are in centre position" symbol (176) until the fork carriage stops rotating.
• Turn the "hydraulic functions" control lever (113) clockwise until the attachment
comes to a stop in the middle of the swivel traverse frame.
The attachment is middle of the swivel traverse frame and the forks are at a right
angle (90°) to the swivel traverse frame. Loads can now be lifted from the front.
Z
If the attachment is not in the home position, you can only travel, lift or lower at a
reduced speed, see page 192.
188
04.19 en-GB
To Next Page
Loading...
Need help?
General
