Manual stacking operation
– Press the deadman button (20).
– Stacking / retrieval can be performed when
the selected nominal height has been
reached.
• Stacking and retrieval are prescribed to
the driver in the driver's display via the
load sensor.
– Do not press the deadman button (20).
– The operator can start to stack and
retrieve goods manually, see page 177.
• On reaching the respective limit position
(traverse / lift height reached), the next
stage can follow if the "Hydraulic
functions" control lever (113) is in
neutral.
Z
The hydraulic speeds are in proportion to the movement of the "Hydraulic functions"
control lever (113).
During the positioning procedure another compartment can be entered. This entry is
shown for approx. 1 sec. in the driver's display and stored in the cache. After
stacking, the shelf is automatically taken from the intermediate log.
Z
The stacking operation can be cancelled by pressing the “CE” button on the
numerical keypad (112) or by pressing the emergency disconnect switch. No "order
processed" message is sent to the truck terminal.
276
04.19 en-GB
To Next Page
Loading...
Need help?
General
