•
Use the power off sequence described in “Powering Off a QFX5110” on page 120 to
safely power off the device.
•
Disconnect the power cords.
•
Ensure that you have disconnected any cables or wires attached to the QFX5110 switch
ports or Precision Time Protocol (PTP) ports.
Ensure that you have the following parts and tools available:
•
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws, for removing the QFX5110 from the rack.
To remove a QFX5110 from a rack or cabinet:
1. Have one person support the weight of the switch while another person uses the
screwdriver to remove the front mounting screws that attach the chassis mounting
brackets to the rack or cabinet.
2. Remove the QFX5110 from the rack or cabinet.
3. Use the screwdriver to remove the mounting screws that attach the mounting blades
attached to the rear of the rack or cabinet.
4. Place the removed screws and mounting blades in a labeled bag. You will need them
when you reinstall the chassis.
5. Transport the QFX5110 to your new location.
Related
Documentation
• Mounting a QFX5110 in a Rack on page 89
123Copyright © 2019, Juniper Networks, Inc.
Chapter 4: Maintaining Components
To Next Page
Loading...
