•
Always use an ESD wrist strap when you are handling components that are subject to
ESD damage, and make sure that it is in direct contact with your skin.
If a grounding strap is not available, hold the component in its antistatic bag (see
Figure 46 on page 159) in one hand and touch the exposed, bare metal of the device
with the other hand immediately before inserting the component into the device.
WARNING: For safety, periodically check the resistance value of the ESD
grounding strap. The measurement must be in the range 1 through
10 Mohms.
•
When handling any component that is subject to ESD damage and that is removed
from the device, make sure the equipment end of your ESD wrist strap is attached to
the ESD point on the chassis.
If no grounding strapis available, touch the exposed, bare metal of the device to ground
yourself before handling the component.
•
Avoid contactbetween the component that is subjectto ESD damage and your clothing.
ESD voltages emitted from clothing can damage components.
•
When removing or installing a component that is subject to ESD damage, always place
it component-side up on an antistatic surface, in an antistatic card rack, or in an
antistatic bag (see Figure 46 on page 159). If you are returning a component, place it in
an antistatic bag before packing it.
Figure 46: Placing a Component into an Antistatic Bag
6xGE SFP
0
1
2
3
4
5
CAUTION
ELECTROSTATIC
SENSITIVE
DEVICES
DO NOT OPEN OR HANDLE
EXCEPT AT A
STATIC-FREE WORKSTATION
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6
can get electrostatically charged. To dissipate this charge, always ground
the cables to a suitable and safe earth ground before connecting them to the
system.
159Copyright © 2019, Juniper Networks, Inc.
Chapter 7: Safety and Compliance Information
To Next Page
Loading...
Need help?
General
