Juniper QFX Series Hardware Guide

NOTE: In North America, AC power cords must not exceed 14.75 feet
(approximately 4.5 meters) in length, to comply with NationalElectrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3). The cords that can be ordered for the QFX
Series switches are in compliance.
Table 15 on page 48 lists AC power cord specifications provided for each country or region.
Table 15: AC Power Cord Specifications
Graphic
Spare Juniper Model
Number
Juniper Model
NumberPlug Standards
Electrical
SpecificationsCountry/Region
CBL-EX-PWR-C13-AUCG_CBL-C13-06-AUIEC 60884-1250 VAC, 10 A, 50 HzAustralia
CBL-EX-PWR-C13-CHCG_CBL-C13-06-CHGB
2099.1–2008
250 VAC, 10 A, 50 HzChina
CBL-EX-PWR-C13-EUCG_CBL-C13-06-EUIEC 60884-1250 VAC, 10 A, 50 HzEurope (except
Italy, Switzerland,
and United
Kingdom)
CBL-EX-PWR-C13-ITCG_CBL-C13-06-ITCEI.23-16/VII250 VAC, 10 A, 50 HzItaly
CBL-EX-PWR-C13-JPCG_CBL-C13-06-JPJIS C8303125 VAC, 12 A, 50 Hz or
60 Hz
Japan
g021274
CBL-EX-PWR-C13-USCG_CBL-C13-06-USNEMA 5-ISP125 VAC, 13 A, 60 HzNorth America
CBL-EX-PWR-C13-KRCG_CBL-C13-06-KRKSC 8305250 VAC, 10 A, 60 HzSouth Korea
CBL-EX-PWR-C13-SZCG_CBL-C13-06-SZSEV 1011–2009250 VAC, 10 A, 50 HzSwitzerland
CBL-EX-PWR-C13-UKCG_CBL-C13-06--UKBS 1363250 VAC, 10 A, 50 HzUnited Kingdom
QFX5110 AC Power Supply LEDs
Figure 17 on page 49 shows the location of the LEDs on the power supply.
Copyright © 2019, Juniper Networks, Inc.48
QFX5110 Switch Hardware Guide

Juniper QFX Series Specifications

General

Category	Switch
Series	QFX
Form Factor	1U, 2U, and modular chassis options
Power Supply	Redundant, hot-swappable power supplies
Cooling	hot-swappable fans
Virtual Chassis	Supported on certain models
Typical Use	Data center, cloud
Operating System	Junos OS
Management	CLI
Key Features	High performance, low latency, automation
Latency	Sub-microsecond latency
Port Density	Varies by model (e.g., QFX5100: up to 48x10GbE + 6x40GbE)