List of Illustrations
1 Getting Started
Figure 1-1 Front panel ............................................................................. 1-7
Figure 1-2 Rear panel .............................................................................. 1-9
Figure 1-3 Typical analog output connections ...................................... 1-11
2 Measurement Concepts
Figure 2-1 BNC Input connector ............................................................. 2-4
Figure 2-2 Maximum input levels ........................................................... 2-5
Figure 2-3 Basic connections .................................................................. 2-6
Figure 2-4 Shielding for measurements (unguarded) .............................. 2-8
Figure 2-5 General purpose test fixture ................................................... 2-9
Figure 2-6 Capacitor test circuit without protection .............................. 2-11
Figure 2-7 Capacitor test circuit with protection ................................... 2-12
Figure 2-8 Floating measurements ........................................................ 2-13
Figure 2-9 Equivalent input impedance with zero check enabled ......... 2-14
3 Measurements
Figure 3-1 Connections for amps ............................................................ 3-4
4 Range, Units, Digits, Rate, and Filters
Figure 4-1 Speed vs. noise characteristics ............................................... 4-5
Figure 4-2 Digital filter; averaging and advanced classifications ............ 4-9
Figure 4-3 Digital filter types; moving and repeating ........................... 4-10
6 Buffer
Figure 6-1 Buffer locations ...................................................................... 6-3
7 Triggering
Figure 7-1 Trigger model — front panel operation ................................. 7-2
Figure 7-2 Trigger model — remote operation ....................................... 7-3
Figure 7-3 Measure action block of trigger model .................................. 7-6
Figure 7-4 Trigger link connection operation ........................................ 7-11
Figure 7-5 Trigger link input pulse specifications ................................. 7-12
Figure 7-6 Trigger link output pulse specifications ............................... 7-12
Figure 7-7 DUT test system .................................................................. 7-13
Figure 7-8 Trigger link connections ...................................................... 7-14
Figure 7-9 Operation model for triggering example ............................. 7-15