Keithley 6485 - Page 23

16 Calibration
Table 16-1 Recommended calibration equipment ................................. 16-4
Table 16-3 Calibration menu ................................................................. 16-5
Table 16-2 Test uncertainty ratios with recommended equipment ........ 16-5
Table 16-4 20 µ A to 20mA range calibration summary ......................... 16-8
Table 16-5 2nA to 2 µ A range calibration summary ............................ 16-10
17 Routine Maintenance
Table 17-1 Line fuse ratings ................................................................... 17-2
Table 17-2 Front panel tests ................................................................... 17-3
B Status and Error Messages
Table B-1 Status and error messages ..................................................... B-2
D DDC Emulation Commands
Table D-1 Device dependent command summary ................................. D-2
Table D-2 Status byte and mask interpretation .................................... D-13
F IEEE-488 Bus Overview
Table F-1 IEEE-488 bus command summary ........................................ F-7
Table F-2 Command codes ..................................................................... F-8
Table F-3 Hexadecimal and decimal command codes ......................... F-11
Table F-4 Typical bus sequence ........................................................... F-12
Table F-5 Typical addressed command sequence ................................ F-12
Table F-6 IEEE command groups ........................................................ F-13
Table F-7 Model 6485 interface function codes ................................... F-14
G IEEE-488 and SCPI Conformance Information
Table G-1 IEEE-488 documentation requirements ................................ G-2
Table G-2 Coupled commands .............................................................. G-3
H Remote Calibration
Table H-1 Calibration commands .......................................................... H-2
Table H-2 Calibration commands by range ........................................... H-4
I Applications Guide
Table I-1 Minimum recommended source resistance values ................. I-6
Table I-2 Internal impedance for zero check transient ......................... I-17