Keysight B1505A User’s Guide, Edition 12 5-27
Measurement Examples
I-V and Capacitance Measurements Using N1272A
8. Click the Apply button to apply the present settings, and then click the Close
button to close the Configuration window.
Preparing Capacitance Measurement Setups
This section shows an example of the setup procedure for the Power MOSET Ciss
(input capacitance) measurement using the N1272A Selector.
Prepare measurement setups as follows:
1. Click the Application Test tab on the main screen. The tab is in the leftmost
column on the screen.
2. Check the PowerMOSET in the Category field. The Library field lists the test
conditions.
3. Click the Ciss (N1272A) in the Library field and Select button sequentially. The
screen changes the display for setting up the Ciss (N1272A).
4. Set up the minimum and maximum values of Ciss at the Device Parameters
field.
5. Set up the measurement conditions at the Test Parameters field.
a. Enter the measurement frequency in the Frequency.
b. Enter the gate-source bias voltage value in the Gate.
c. Enter or select the drain-source voltage sweep conditions in the Drain.
d. Set up the other parameters if necessary.
For details of the setting parameters, see the help message for each test
definition.
To Next Page
Loading...
Need help?
General
