4-16 Keysight B1505A User’s Guide, Edition 12
Installation
About Plug-in Modules
About Plug-in Modules
Module locations when the B1505A is shipped from the factory are shown in Table
4-2. This table shows the relative locations by the module types. The same type of
modules must be installed in the contiguous slots.
For example, if the module configuration is two HPSMU, one MFCMU, one
HCSMU, and one HVSMU, the B1505A will be shipped with the HPSMU of the
slots 1 to 4, the MFCMU of the slot 5, the HCSMU of the slots 6 to 7, the HVSMU
of the slots 8 to 9, and the blank panel of the slot 10.
Module installation must be carried out at an Keysight Technologies service center.
Contact Keysight Technologies for the module installation. Then send the following
equipment and accessories to Keysight Technologies.
• B1505A
• Plug-in modules to be installed
WARNING To prevent electrical shock, turn the instrument off and remove the power
cable before removing the connection cables.
Afin d'éviter toute décharge électrique, mettez l'appareil hors tension et
débranchez le cordon d'alimentation avant de retirer les câbles de connexion.
NOTE Module locations after servicing
After the module installation, upgrade, and so on, the B1505A will be returned with
the module configuration decided by the rule shown in Table 4-2. If you want to
change the module locations, consult the service personnel before servicing.
To Next Page
Loading...
Need help?
General
