3-28 Keysight B1505A User’s Guide, Edition 12
Accessories
• Output of N1261A-002
BNC connectors. Force and Sense must be extended to a terminal of a DUT.
And they must be connected together at the device end. For making the
connection, use high voltage cable with BNC(m) connector, manipulators, and
such.
• Output of N1261A-004
SHV(jack) connectors. Force and Sense must be extended to a terminal of a
DUT. And they must be connected together at the device end. For making the
connection, use high voltage cable with SHV(plug) connector, manipulators,
and such.
N1262A Resistor Box
Resistor box for reducing the risk of device breakdown or preventing SMU from
oscillation. 1 k (± 200 Vdc), 1 k (± 3000 Vdc), 100 k (± 3000 Vdc), or 1 M
(± 3000 Vdc). The N1262A is used with a DUT interface such as your own test
fixture and prober station, not the N1259A/N1265A test fixture.
N1262A-001: 1 M (± 3000 Vdc) resistor, HV(jack)-SHV(jack)
N1262A-002: 100 k (± 3000 Vdc) resistor, HV(jack)-SHV(jack)
N1262A-010: 1 k (± 200 Vdc) resistor, Triaxial(f)-Triaxial(f)
N1262A-011: 1 k (± 3000 Vdc) resistor, HV(jack)-SHV(jack)
N1262A-020: Universal resistor box, Triaxial(f)-Triaxial(f)
N1262A-021: Universal resistor box, HV(jack)-SHV(jack)
N1262A-023: Universal resistor box, UHV(jack)-UHV(jack)
N1262A-036: 50 termination adapter
Universal resistor box is kind of a do-it-yourself kit for installing a resistor you
want.
50 termination adapter is a BNC(f)-BNC(m) adapter which contains 50 resistor
between signal line and shield. If a SMU is used as the gate drive for the
measurement using HVMCU, UHVU, or UHCU, the SMU may cause oscillation.
Then this adapter should be connected between the gate drive output and a DUT
terminal. This will be effective for preventing oscillation.
To Next Page
Loading...
Need help?
General
