Keysight B1505A User’s Guide, Edition 12 1-7
Getting Started
To Launch EasyEXPERT
If Only One Workspace Exists
For the screen as shown in Figure 1-1, perform the following steps.
• If you do not want to create a workspace, select the Yes radio button and click
OK. Skip to “To Use Tracer Test Mode” on page 1-10, “To Use Application Test
Mode” on page 1-12, or “To Use Classic Test Mode” on page 1-14.
• If you want to create a workspace, select the No, I want to start a new session.
radio button and click Next. The B1500A displays the screen as shown in Figure
1-2. Skip to “To Create Workspace” on page 1-8.
• If you want to manage workspaces, select the No, I want to manage Workspaces.
radio button and click Next. The B1500A displays the screen as shown in Figure
1-3. Skip to “To Select Workspace” on page 1-9.
Figure 1-1 If Only One Workspace Exists
NOTE Work on the same setups and data next time
If this check box is checked, the workspace selection screen will be skipped at the
next startup and EasyEXPERT will be launched with the workspace used at the last
operation. To perform this setup again, click the File > Close Workspace menu on
the EasyEXPERT main screen.
To Next Page
Loading...
Need help?
General
