Keysight B1505A User’s Guide, Edition 12 1-17
Getting Started
To Perform Measurement
To Use Test Result Editor
The Test Result Editor provides the following GUI to set a flag and remarks to the
test result record.
• Save button and Delete button
Divides test records into groups, Save and Delete.
Test records in Save-group are always listed in the lower area of the
EasyEXPERT main screen.
Test records in Delete-group can be listed when Results > Filter >
Show Deleted Data is checked.
• Flags buttons
The following buttons are available. You can set one of the following flags.
• Important ! button
Sets the important flag (!) to the test result record.
• Valid # button
Sets the valid flag (#) to the test result record.
• Questionable ? button
Sets the questionable flag (?) to the test result record.
• Remarks field
You can enter characters into this field. The characters will be recorded as the
Remarks value of the test result record.
• OK button
Applies the setup on the Test Result Editor, and closes this dialog box.
To Next Page
Loading...
Need help?
General
