Keysight Technologies J-BERT M8020A - Page 128

128 Keysight M8070A Programming Guide
5 SCPI Command Reference
:STATus:INSTrument:RCINput?
Syntax :STATus:INSTrument:RCINput? ‘identifier’
Input
Parameters
‘identifier’: ‘M1.ClkGen’
Return Range 0|1
Description This query indicates the input state of the reference clock.
Example :STAT:INST:RCIN? ‘M1.ClkGen’
:STATus:INSTrument:RUN?
Syntax :STATus:INSTrument:RUN? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2' or ‘M1.System’
Return Range 0|1
Description This query indicates if the input is operating properly. A true (1) indicates
the input is operating properly.
Example :STAT:INST:RUN? ‘M1.DataIn1’
:STATus:INSTrument:CDR:ULOCked?
Syntax :STATus:INSTrument:CDR:ULOCked? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2' or ‘M1.System’
Return Range 0|1
Description This query indicates the lock state of the clock data recovery. A true (1)
indicates an unlocked state.
Example :STAT:INST:CDR:UNLOC? ‘M1.DataIn1’