Keysight M8070A Programming Guide 423
SCPI Command Reference 5
:PLUGin:PSWEep:RESet
Syntax :PLUGin:PSWEep:RESet ‘identifier’
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
Description This command resets a parameter sweep measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example The following example resets a parameter sweep measurement addressed
with the measurement name identifier called ‘ParameterSweep1’:
:PLUG:PSWE:RES ‘ParameterSweep1’
:PLUGin:PSWEep:STARt
Syntax :PLUGin:PSWEep:STARt ‘identifier’
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
Description This command starts a parameter sweep measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example The following example starts a parameter sweep measurement addressed
with the measurement name identifier called ‘ParameterSweep1’:
:PLUG:PSWE:STAR ‘ParameterSweep1’
:PLUGin:PSWEep:STOP
Syntax :PLUGin:PSWEep:STOP ‘identifier’
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
Description This command stops a parameter sweep measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
To Next Page
Loading...
