Keysight M8070A Programming Guide 201
SCPI Command Reference 5
[:SOURce]:INTerference:SINUsoidal Subnode
This subnode controls the configuration when AWG is used as sinusoidal
interference source. It has the following SCPI structure:
This subnode has the following command:
[:SOURce]:INTerference:SINusoidal:FREQuency[?]
Syntax [:SOURce]:INTerference:SINusoidal:FREQuency ‘Identifier’, <NRf>
[:SOURce]:INTerference:SINusoidal:FREQuency? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
Description This command sets the sinusoidal interference frequency in Hz.
This SCPI is applicable for M8195A and M8196A.
Example :INT:SIN:FREQ ‘M2.DataOut1’,1e9
[:SOURce]
:INTerference
:SINusoidal
:FRQuency[?]
To Next Page
Loading...
