308 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:OTIMing:ACQuisition:ALOCation[?]
Syntax :PLUGin:ERATio:ACQuisition:ALOCation ‘identifier’, <location-string>
:PLUGin:ERATio:ACQuisition:ALOCation? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
<location-string>: Specify location or group name identifier.
Return Range <location or group name>
Description This command associates the location or group name identifier with a
measurement name identifier against which the data acquisition is
performed. The group name identifier is defined using the
:SYSTem:INSTrument:GROup:DEFine command.
:NEW :PLUGin:OTIMing:NEW on page 316
:RESet :PLUGin:OTIMing:RESet on page 317
:STARt :PLUGin:OTIMing:STARt on page 317
:STOP :PLUGin:OTIMing:STOP on page 318
:BREak :PLUGin:OTIMing:BREak on page 318
:STEP :PLUGin:OTIMing:STEP on page 319
:CONTinue :PLUGin:OTIMing:CONTinue on page 320
:GRAPh? :PLUGin:OTIMing:GRAPh? on page 320
:RUN:HISTory[:STATe] :PLUGin:OTIMing:RUN:HISTory[:STATe][?]
on page 321
:RUN:HISTory:CLEar :PLUGin:OTIMing:RUN:HISTory:CLEar on
page 321
:RUN:LOG? :PLUGin:OTIMing:RUN:LOG? on page 322
:RUN:MESSage? :PLUGin:OTIMing:RUN:MESSage? on page 322
:RUN:PROGress? :PLUGin:OTIMing:RUN:PROGress? on
page 323
:RUN[:STATus]? :PLUGin:OTIMing:RUN[:STATus]? on page 323
:FETCh :PLUGin:OTIMing:FETCh Subnode on page 324
Name Description under
To Next Page
Loading...
Need help?
General
