Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 193
SCPI Command Reference 5
[:SOURce]:INTerference[:LEVel]:DMODe:SOURce[?]
Syntax [:SOURce]:INTerference[:LEVel]:DMODe:SOURce ‘identifier’,
<HFRequency|LFRequency>
[:SOURce]:INTerference[:LEVel]:DMODe:SOURce? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<HFRequency|LFRequency>: Select HF or LF generator.
Return Range HFR|LFR
Description This command selects the high frequency or low frequency generator type
for differential mode interference.
This SCPI is applicable for M8041A and M8051A.
Example :INT:DMOD:SOUR ‘M2.DataOut1’, LFR
[:SOURce]:INTerference[:LEVel]:DMODe:GAIN[?]
Syntax [:SOURce]:INTerference[:LEVel]:DMODe:GAIN ‘identifier’, <NRf>
[:SOURce]:INTerference[:LEVel]:DMODe:GAIN? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<NRf>: Set differential mode interference gain.
Return Range 0.01 to 1.0
Description This command sets the linear gain of the differential mode interference.
This SCPI is applicable for M8061A and M8062A.
Example :INT:DMOD:GAIN ‘M2.DataOut1’, 0.5
[:SOURce]:INTerference:ISYMbol[:STATe][?]
Syntax [:SOURce]:INTerference:ISYMbol[:STATe] 'Identifier', <0|1|ON|OFF>
[:SOURce]:INTerference:ISYMbol[:STATe]? 'Identifier'
Input
Parameters
Identifier: 'M*.DataOut1', 'M*.DataOut2', or ‘M*.DataOut’
Return Range 0|1

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English