Keysight M8070A Programming Guide 173
SCPI Command Reference 5
[:SOURce]:JITTer:LFRequency:RSSClocking Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 42
[:SOURce]:JITTer:LFRequency:RSSClocking[:STATe][?]
Syntax [:SOURce]:JITTer:LFRequency:RSSClocking[:STATe] ‘identifier’,
<ON|OFF|1|0>
[:SOURce]:JITTer:LFRequency:RSSClocking[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.ClkOut', 'M*.DataOut1', 'M*.DataOut2', or ‘M*.DataOut’
<ON|OFF|1|0>: Enable/disable residual spread spectrum clocking.
Return Range 1|0
Description This command enables/disables the residual spread spectrum clocking
(rSSC).
This SCPI is applicable for M8041A, M8051A, M8061A and M8062A.
Example :JITT:LFR:RSSC ‘M2.DataOut2’, on
Name Description under
[:STATe][?] [:SOURce]:JITTer:LFRequency:RSSClocking
[:STATe][?] on page 173
:AMPLitude[?] [:SOURce]:JITTer:LFRequency:RSSClocking
:AMPLitude[?] on page 174
:FREQuency[?] [:SOURce]:JITTer:LFRequency:RSSClocking
:FREQuency[?] on page 174
To Next Page
Loading...
