Keysight Technologies J-BERT M8020A

Keysight M8070A Programming Guide 137
SCPI Command Reference 5
This subsystem has the following commands and subnodes:
Table 31
[:SOURce]:FREQuency[?]
Syntax [:SOURce]:FREQuency ‘identifier’, <NRf>
[:SOURce]:FREQuency? ‘identifier’
Input
Parameters
‘identifier’: ‘M1.ClkGen’
<NRf>: Set system frequency.
Return Range For M8041A: 256 MHz to 16.207 GHz
For M8195A: 256 MHz to 32.5 GHz
For M8045A: 2.025 GHz to 64.828 GHz
Name Description under
:FREQuency[?] [:SOURce]:FREQuency[?] on page 137
:PERiod[?] [:SOURce]:PERiod[?] on page 138
:DRATe[?] [:SOURce]:DRATe[?] on page 138
:MEMory:CONFigure[:VALue][?] [:SOURce]:MEMory:CONFigure[:VALue][?]
on page 139
Subnodes
:PULse [:SOURce]:PULSe Subnode on page 141
:VOLTage [:SOURce]:VOLTage Subnode on page 145
:JITTer [:SOURce]:JITTer Subnode on page 149
:JITTer:HFRequency [:SOURce]:JITTer:HFRequency Subnode on
page 152
:JITTer:LFRequency [:SOURce]:JITTer:LFRequency Subnode on
page 169
:JITTer:SWEep [:SOURce]:JITTer:SWEep Subnode on
page 175
:SSCLocking [:SOURce]:SSCLocking Subnode on page 182
:INTerference [:SOURce]:INTerference Subnode on page 187