Keysight M8070A Programming Guide 139
SCPI Command Reference 5
Description This command/query sets/gets the data rate.
This SCPI is applicable for M8062A.
Example :DRAT 'M2.ClkGen', 10e9
[:SOURce]:MEMory:CONFigure[:VALue][?]
Syntax [:SOURce]:MEMory:CONFigure ‘identifier’, <SINGle | DUAL | FOUR |
RANDom | SINusoidal>
[:SOURce]:MEMory:CONFigure? ‘identifier’
Input
Parameters
‘identifier’: ‘M1’
SINGle | DUAL | FOUR | RANDom | SINusoidal
Case 1 - The following description is applicable when the four channel
license has been purchased:
• SINGle: DataOut1 will be sourced from extended memory and the other
channels will be sourced from module internal memory. The data rate
range in this mode is 256 Mb/s … 32.5 Gb/s.
• DUAL: DataOut1 and DataOut2 will be sourced from extended memory
and the other channels will be sourced from module internal memory.
The data rate range in this mode is 256 Mb/s … 16.250 Gb/s.
• FOUR: All four channels will be sourced from extended memory. The
data rate range in this mode is 256 Mb/s … 8.125 Gb/s.
• RANDom: All the available channels are used to generate random
interference.
• SINusoidal: All the available channels are used to generate random
interference.
To Next Page
Loading...
