192 Keysight M8070A Programming Guide
5 SCPI Command Reference
[:SOURce]:INTerference[:LEVel]:DMODe[:STATe][?]
Syntax [:SOURce]:INTerference[:LEVel]:DMODe[:STATe] ‘identifier’, <ON|OFF>
[:SOURce]:INTerference[:LEVel]:DMODe[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT’, ‘M*.DATAOUT1’, or ‘M*.DataOut2’
<ON|OFF>: Turn differential mode interference on/off.
Return Range ON|OFF
Description This command turns differential mode interference on/off.
This SCPI is applicable for M8041A, M8051A, M8061A and M8062A.
Example :INT:DMOD ‘M2.DataOut1’, on
[:SOURce]:INTerference[:LEVel]:DMODe:AMPLitude[?]
Syntax [:SOURce]:INTerference[:LEVel]:DMODe:AMPLitude ‘identifier’, <NRf>
[:SOURce]:INTerference[:LEVel]:DMODe:AMPLitude? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<NRf>: Set differential mode interference amplitude.
Return Range 0 mV to 360 mV
Description This command sets the amplitude of the differential mode interference in
volts. Acceptable units include mV, V and and exponents (for example,
100E-3 is the same as 100 mV).
This SCPI is applicable for M8041A and M8051A.
Example :INT:DMOD:AMPL ‘M2.DataOut1’, 100mV
To Next Page
Loading...
