334 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:OTIMing:FETCh:FREQuency?
Syntax :PLUGin:OTIMing:FETCh:FREQuency? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
Description This command returns the currently set frequency of the measurement.
The frequency is set using the :SOURce:FREQuency command.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example :PLUG:OTIM:FETC:FREQ? ‘Output Timing 1’
("M1.DataIn1",5.000000000000000E+009)
To Next Page
Loading...
