Keysight M8070A Programming Guide 129
SCPI Command Reference 5
TRIGger Subsystem
The TRIGger subsystem selects the trigger mode at the TRIG OUT port.
This subsystem has the following SCPI structure:
Table 30
Name Description under
[:SOURce] :TRIGger[:SOURce][?] on page 130
[:SOURce]:FREQuency? :TRIGger[:SOURce]:FREQuency? on page 131
:INTernal[:SOURce][?] :TRIGger:INTernal[:SOURce][?] on page 131
:REFerence[:FREQuency][?] :TRIGger:REFerence[:FREQuency][?] on
page 132
:DIRect[:FREQuency][?] :TRIGger:DIRect[:FREQuency][?] on page 132
:DIRect[:FREQuency]:DETect :TRIGger:DIRect[:FREQuency][?] on page 132
:CMULtiplier:LBWidth[?] :TRIGger:CMULtiplier:LBWidth[?] on page 133
To Next Page
Loading...
