Keysight M8070A Programming Guide 263
SCPI Command Reference 5
N71000 Subsystem
The N1000 subsystem is used to control external clock recovery
instruments that are themselves controlled from within the FlexDCA
N1000-Series System Software.
It is possible to share one FlexDCA instance among multiple M8070A
instances. However, to ensure correct access control, all M8070A
instances have to be executed by the same PC.
All the commands used in this subsystem are basically identical with the
SCPI commands of FlexDCA N1000-Series System Software. The only
difference is that the M8070A does not use a suffix to address specific
parts of the instrument, but instead always has the identifier parameter as
first argument of the SCPI commands.
Detailed information about the features and SCPI commands of the
supported clock recoveries can be found in the corresponding
documentation:
N1076A Data Sheet
http://literature.cdn.keysight.com/litweb/pdf/5992-1620EN.pdf?id=2772
197
N1076A User Guide
http://literature.cdn.keysight.com/litweb/pdf/N1076-90001.pdf?id=2784
631
N1010A FlexDCA Online Help
http://www.keysight.com/main/redirector.jspx?action=ref&cname=EDITO
RIAL&ckey=2038334&lc=ger&cc=DE&nfr=-11143.0.00
The minimum required version of the FlexDCA N1000-Series System
Software is A.05.61.23.
To Next Page
Loading...
Need help?
General
