Keysight Technologies J-BERT M8020A

414 Keysight M8070A Programming Guide
5 SCPI Command Reference
characters in the log then followed by the log message.
For example:
#10 means, there is 1 digit after 1 and there is 0 character in the log.
#2492 means, there are 3 digits after 2 and there are 492 characters in the
log message.
:PLUGin:EDIagram:SHOW Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 82
Name Description under
:CONTour :PLUGin:EDIagram:SHOW:CONTour[?] on page 415
:LEGend
:PLUGin:EDIagram:SHOW:CONTour:LEGend[?] on
page 415
:UNIT :PLUGin:EDIagram:SHOW:UNIT[?] on page 415
:WAVEform :PLUGin:EDIagram:SHOW:WAVeform[?] on page 416
:SGRaph :PLUGin:EDIagram:SHOW:WAVeform:SGRaph[?]
on page 416
:THReshold :PLUGin:EDIagram:SHOW:WAVeform:THReshold[
?]
on page 417
:CONTour[?]
:LEGend [?]
:UNIT[?]
:SHOW
:WAVEform[?]
:SGRaph[?]
:THReshold[?]