Keysight Technologies J-BERT M8020A - Page 413

Keysight M8070A Programming Guide 413
SCPI Command Reference 5
:PLUGin:EDIagram:RUN:HISTory[:STATe][?]
Syntax :PLUGin:EDIagram:RUN:HISTory[:STATe] 'Identifier', <0|1|ON|OFF>
:PLUGin:EDIagram:RUN:HISTory[:STATe]? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
Return Range 0|1
Description This command enables/disables the storage of eye diagram measurement
results addressed by the measurement name identifier.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:RUN:HIST 'MyMeasurement', 1
:PLUGin:EDIagram:RUN:HISTory:CLEar
Syntax :PLUGin:EDIagram:RUN:HISTory:CLEar 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
Description This command deletes the eye diagram measurement history addressed
by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:RUN:HIST:CLE 'MyMeasurement'
:PLUGin:EDIagram:RUN:LOG?
Syntax :PLUGin:EDIagram:RUN:LOG? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
Description This command returns logs for the addressed measurement.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:RUN:LOG? 'MyMeasurement'
The format of log returned is in the following way:
#XY Message Log
where X denotes the length of digits for Y, Y denotes the number of