94 Keysight M8070A Programming Guide
4 SCPI Command Language
Command Line Arguments
(See Communication on page 95 for details about /Socket, /Telnet, /Inst,
/AutoID, /NoAutoID, /FallBack).
Table 19 Command line arguments
Argument Description
/AutoId Start in auto ID mode (this is the default)
[optional]
/NoAutoId Do not start in auto ID mode - use
communication parameters from command
line [optional]
/FallBack Use auto ID mode if the communication
parameters from the command line don't
work [optional]
/Socket <socket port> Set the socket port for the SCPI
communication (only used with /NoAutoId)
[optional]
/Telnet <telnet port> Set the telnet port for the SCPI
communication (only used with /NoAutoId)
[optional]
/Inst <instrument
number>
Set the instrument number for VXI-11.3 and
HiSLIP SCPI communication [optional]
/rcl Recall last used setting [optional]
/rst Reset to factory default [optional]
/IgnoreAwg M8070A software don't grab M8195A
modules [optional]
To Next Page
Loading...
