Keysight Technologies J-BERT M8020A

Keysight M8070A Programming Guide 259
SCPI Command Reference 5
CLOCk Subsystem
The CLOCk subsystem is used to detect clock source or to set the clock
frequency applied to input or output channel.
This subsystem has the following SCPI structure:
This subsystem has the following commands:
Table 59
NOTE
M8061A has only DataOut with Clock functional block, so the commands
are only supported in the DataOut location and not in the DataIn location.
Name Description under
[:SOURce][?] :CLOCk[:SOURce][?] on page 260
:CLOCk[:SOURce]:CRECovery:SEL
ect[?]
:CLOCk[:SOURce]:CRECovery:SELect[?] on
page 260
:FREQuency [?] :CLOCk[:SOURce]:CRECovery:SELect[?] on
page 260
:FREQuency:MULTiplier[?] :CLOCk:FREQuency:MULTiplier[?] on page 261
:TRACk[:STATe][?] :CLOCk:TRACk[:STATe][?] on page 262
:CLOCk
[:SOURce][?]
:FREQuency [?]
:MULTiplier[?]
:TRACk
[:STATe][?]
:CRECovery:SELect[?]