420 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUG:PSWE:NEW ‘ParameterSweep3’
The command and returned list would look like the following:
:PLUG:PSWE:CAT?
“ParameterSweep1”,”ParameterSweep2”,”ParameterSweep3”
:PLUGin:PSWEep:DELete
Syntax :PLUGin:PSWEep:DELete ‘identifier’
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
Description This command deletes a previously created parameter sweep
measurement addressed by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example The following example deletes a parameter sweep measurement
addressed by the measurement name identifier called ‘Parameter Sweep
1’:
:PLUG:PSWE:DEL ‘Parameter Sweep 1’
:PLUGin:PSWEep:FETCh:DATA?
Syntax :PLUGin:PSWEep:FETCh:DATA? ‘identifier’[,‘Location’]
Input
Parameters
‘Identifier’: Specify the plugin name. For e.g. ‘ParameterSweep1’
[‘Location’]: Specify location (optional) in case of location group
Description This command returns the raw data of the parameter sweep measurement
associated with a specific measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example :PLUG:PSWE:FETC:DATA? ‘ParameterSweep1’, ‘M1.DataIn1’
A measurement run on a location identifier (for example, ‘M1.DataIn1’) will
return following result:
("M1.DataIn1",1491575569.21202,2500015,2499985,1250000,1249985,-
6.7E-09,1491575569.22802,2499982,2500018,1249982,1250000, ...)
The first item in the comma separated list is the name of the location for
which the data is being queried. Rest of the values in the comma
To Next Page
Loading...
Need help?
General
