Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 153
SCPI Command Reference 5
[:SOURce]:JITTer:HFRequency:UNIT[?]
Syntax [:SOURce]:JITTer:HFRequency:UNIT ‘identifier’, <UINTerval|TIME>
[:SOURce]:JITTer:HFRequency:UNIT? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', or 'M*.DataOut'
<UINTerval|TIME>: Specify jitter parameter units.
Return Range UINT|TIME
Description Specifies whether the jitter parameters are to be specified/returned in
seconds (TIME) or unit intervals (UINTerval).
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8045A.
This SCPI is also available on M8195A for DataOut1 to 4.
Example :JITT:HFR:UNIT ‘M1.DataOut1’, TIME
[:SOURce]:JITTer:HFRequency:EXTernal[:STATe][?]
Syntax [:SOURce]:JITTer:HFRequency:EXTernal[:STATe] ‘identifier’, <ON|OFF|1|0>
[:SOURce]:JITTer:HFRequency:EXTernal[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.ClkOut', 'M*.DataOut1' or 'M*.DataOut2'
<ON|OFF|1|0>: Enable/disable external jitter input.
Return Range 1|0
Description Enable/disable the external jitter input connector for Data Out1, Data Out2
and Clock Out. The name of the connectors are DATA MOD IN and CLK
MOD IN.
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:HFR:EXT:STAT ‘M1.DataOut2’, on
:RANDom [:SOURce]:JITTer:HFRequency:RANDom
Subnode on page 162
:SPECtrally [:SOURce]:JITTer:HFRequency:SPECtrally
Subnode on page 166
Name Description under

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English