Keysight M8070A Programming Guide 17
Programming Basics 1
1-channel, 32 Gb/s (Pattern Generator only or full BERT)
A typical configuration for an M8020A 32 Gb/s full BERT consists of the
5-slot M9505A AXIe Chassis, an M8041A module, and an M8062A module.
The M8041A occupies three slots and the M8062A occupies two slots.
Figure 4 M8020A configuration for 32 Gb/s BERT
M8030A Modular Configuration
The M8030A is a modular test solution which can be tailored to specific
needs from two channels with one M8041A to up to 10 channels.
The modules must be installed in the M9514A AXIe 14-slot chassis as
shown in
Table 3 on page -17:
Table 3 M8030A modules’ arrangement in the M9514A AXIe chassis
Slot Number Module
# 1 For M8030A-BU1, M9537A AXIe embedded controller. For M8030A-BU2, this
slot is empty and covered with filler front-panel
# 2-4 M8041A module
# 5-6 M8051A module
# 7 M9521A AXIe system module, always included in M8030A-BU1 or
M8030A-BU2, mandatory
# 8-9 M8051A module
To Next Page
Loading...
Need help?
General
