Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 419
SCPI Command Reference 5
This subnode has the following commands and subnodes:
Table 83
:PLUGin:PSWEep:CATalog?
Syntax :PLUGin:PSWEep:CATalog?
Description This command returns a list of all created parameter sweep names
currently available for measuring.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A, M8045A
and M8046A.
Example Assume three parameter sweep measurements named as:
‘ParameterSweep1’, ‘ParameterSweep2’ and ‘ParameterSweep3’ are
created using NEW command:
:PLUG:PSWE:NEW ‘ParameterSweep1’
:PLUG:PSWE:NEW ‘ParameterSweep2’
Name Description under
:CATalog?
:PLUGin:PSWEep:CATalog? on page 419
:DELete
:PLUGin:PSWEep:DELete on page 420
FETCh:DATA? :PLUGin:PSWEep:FETCh:DATA? on page 420
GRAPh? :PLUGin:PSWEep:GRAPh? on page 421
:NEW :PLUGin:PSWEep:NEW on page 422
:RESet :PLUGin:PSWEep:RESet on page 423
:STARt :PLUGin:PSWEep:STARt on page 423
:STOP :PLUGin:PSWEep:STOP on page 423
Subnodes
:ACQuisition: :PLUGin:PSWEep:ACQuisition Subnode on page 424
:RUN :PLUGin:PSWEep:RUN Subnode on page 430
:SHOW :PLUGin:PSWEep:SHOW Subnode on page 434

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English