Keysight Technologies J-BERT M8020A - Page 415

Keysight M8070A Programming Guide 415
SCPI Command Reference 5
:PLUGin:EDIagram:SHOW:CONTour[?]
Syntax :PLUGin:EDIagram:SHOW:CONTour 'Identifier', <0|1|ON|OFF>
:PLUGin:EDIagram:SHOW:CONTour? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
Return Range 0|1
Description This command shows/hides the contour lines on the graph.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:SHOW:CONT 'MyMeasurement', 1
:PLUGin:EDIagram:SHOW:CONTour:LEGend[?]
Syntax :PLUGin:EDIagram:SHOW:CONTour:LEGend 'Identifier', <0|1|ON|OFF>
:PLUGin:EDIagram:SHOW:CONTour:LEGend? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
Return Range 0|1
Description The command shows/hides contour legends.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:SHOW:CONT:LEG 'MyMeasurement', 1
:PLUGin:EDIagram:SHOW:UNIT[?]
Syntax :PLUGin:EDIagram:SHOW:UNIT 'Identifier', <UNIT | TIME >
:PLUGin:EDIagram:SHOW:UNIT? 'Identifier',
Input
Parameters
Identifier: 'MyMeasurement'
Return Range UNIT | TIME
Description The command sets the display unit. It can be either in terms of seconds or
UNIT.