416 Keysight M8070A Programming Guide
5 SCPI Command Reference
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:SHOW:UNIT 'MyMeasurement', UNIT
:PLUGin:EDIagram:SHOW:WAVeform[?]
Syntax :PLUGin:EDIagram:SHOW:WAVeform 'Identifier', <0|1|OFF|ON>
:PLUGin:EDIagram:SHOW:WAVeform? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
<0|1|OFF|ON>: Show/hide waveform
Return Range 0|1
Description This command shows/hides the waveform. When this feature is enabled,
the waveform is displayed together with the contour lines. Disabling this
feature will only display contour lines, if available.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:SHOW:WAV 'MyMeasurement', 1
:PLUGin:EDIagram:SHOW:WAVeform:SGRaph[?]
Syntax :PLUGin:EDIagram:SHOW:WAVeform:SGRaph 'Identifier', <0|1|OFF|ON>
:PLUGin:EDIagram:SHOW:WAVeform:SGRaph? 'Identifier'
Input
Parameters
Identifier: 'MyMeasurement'
<0|1|OFF|ON>: Smooth waveform graphics.
Return Range 0|1
Description This command smooths out the waveform graphics. When this feature is
enabled, the waveform is displayed together with the contour lines.
Disabling this feature will only display contour lines, if available.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :PLUG:EDI:SHOW:WAV:SGR 'MyMeasurement', 1
To Next Page
Loading...
