Keysight Technologies J-BERT M8020A

Keysight M8070A Programming Guide 141
SCPI Command Reference 5
[:SOURce]:PULSe Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 32
[:SOURce]:PULSe:FILTer:TYPE[?]
Syntax [:SOURce]:PULSe:FILTer:TYPE ‘identifier’, <GAUS | RCOS>
[:SOURce]:PULSe:FILTer:TYPE? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', 'M*.DataOut3', or 'M*.DataOut4'
<GAUS | RCOS>
Name Description under
:PULSe:FILTer:TYPE[?] [:SOURce]:PULSe:FILTer:TYPE[?] on page 141
:PULSe:ROFFfactor[?] [:SOURce]:PULSe:ROFFfactor[?] on page 142
:PULSe:DELay[?] [:SOURce]:PULSe:DELay[?] on page 142
:PULSe::TRANsition:FIXed[?] [:SOURce]:PULSe:TRANsition:FIXed[?] on
page 143
:PULSe::TRANsition[:LEADing][?] [:SOURce]:PULSe:TRANsition[:LEADing][?]
on page 143
[:SOURce]
:PULSe
:FILTer
:TYPE[?]
:ROFFfactor[?]
:DELay[?]
:TRANsition
:FIXed[?]
[:LEADing][?]