Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 317
SCPI Command Reference 5
:PLUGin:OTIMing:DELete
Syntax :PLUGin:OTIMing:DELete ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to delete.
Description This command deletes a previously created output timing measurement
addressed by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example The following example deletes an output timing measurement with the
measurement name identifier called ‘MyOutputTiming’:
:PLUG:OTIM:DEL ‘MyOutputTiming’
:PLUGin:OTIMing:RESet
Syntax :PLUGin:OTIMing:RESet ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to reset.
Description This command resets an output timing measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example The following example resets an output timing measurement addressed
with the measurement name identifier called ‘MyOutputTiming’:
:PLUG:OTIM:RES ‘MyOutputTiming’
:PLUGin:OTIMing:STARt
Syntax :PLUGin:OTIMing:STARt ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to start.
Description This command starts an output timing measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8062A and M8046A.
Example The following example starts an output timing measurement with the
measurement name identifier called ‘MyOutputTiming’:
:PLUG:OTIM:STAR ‘MyOutputTiming’

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English