Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 183
SCPI Command Reference 5
[:SOURce]:SSCLocking[:STATe][?]
Syntax [:SOURce]:SSCLocking[:STATe] ‘identifier’, <ON|OFF|1|0>
[:SOURce]:SSCLocking[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.ClkGen'
<ON|OFF|1|0>: Enable/disable spread spectrum clocking.
Return Range 1|0
Description This command enables/disables spread spectrum clocking (SSC) state.
The SSC mode can be only enabled if Global SSC state is activated.
This SCPI is applicable for M8041A, M8195A, M8196A and M8045A.
Example The below mentioned SCPI command turns ON the SSC state:
:SSCL ‘M1.ClkGen’, ON
The below mentioned SCPI command queries the SSC:
:SSCL? ‘M1.ClkGen’
1
:SOURce]:SSCLocking:GLOBal[:STATe][?]
Syntax [:SOURce]:SSCLocking:GLOBal[:STATe] ‘identifier’, <ON|OFF|1|0>
[:SOURce]:SSCLocking:GLOBal[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M1.System'
<ON|OFF|1|0>: Enable/disable spread spectrum clocking.
Return Range 1|0
Description This command turns the spread spectrum clocking (SSC) mode globally on
or off. This means that SSC will be only enable for a specific module if the
module specific SSC switch and the global SSC switch are both turned on,
otherwise SSC is disabled.
Example SOUR:SSCL:GLOB ‘M1.System’,on.

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English