Keysight M8070A Programming Guide 229
SCPI Command Reference 5
This SCPI is applicable for M8195A and M8196A.
Example :OUTP:DEMB:SPAR:PROF ‘M1.DataOut1’,
”factory/huber_suhner_cable.s2p”
:OUTPut:DEMBedding:SPARameter:IPORt[?]
Syntax :OUTPut:DEMBedding:SPARameter:IPORt ‘identifier’, <NRf>
:OUTPut:DEMBedding:SPARameter:IPORt? ‘identifier’
Input
Parameters
‘identifier’:'M*.DataOut1’,‘M*.DataOut2’,‘M*.DataOut3’,or ‘M*.DataOut4’
1|2|3|4:
Return Range 1|2|3|4; depends upon the selected S parameter file.
Description This command selects the input port in the S-Parameter profile.
The query return the present setting.
This SCPI is applicable for M8195A and M8196A.
Example :OUTP:DEMB:SPAR:IPOR ‘M1.DataOut1’, 1
:OUTPut:DEMBedding:SPARameter:OPORt[?]
Syntax :OUTPut:DEMBedding:SPARameter:OPORt ‘identifier’, <NRf>
:OUTPut:DEMBedding:SPARameter:OPORt? ‘identifier’
Input
Parameters
‘identifier’:'M*.DataOut1’,‘M*.DataOut2’,‘M*.DataOut3’,or ‘M*.DataOut4’
1|2|3|4:
Return Range 1|2|3|4; depends upon the selected S-parameter file.
Description This command selects the output port in the S-Parameter profile.
The query return the present setting.
This SCPI is applicable for M8195A and M8196A.
Example :OUTP:DEMB:SPAR:OPOR ‘M1.DataOut1’, 2
To Next Page
Loading...
