298 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:ERATio:DELete
Syntax :PLUGin:ERATio:DELete ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to delete.
Description This command deletes a previously created error ratio measurement
addressed by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example The following example deletes an error ratio measurement addressed by
the measurement name identifier called ‘MyMeasurement’:
:PLUG:ERAT:DEL ‘MyMeasurement’
:PLUGin:ERATio:RESet
Syntax :PLUGin:ERATio:RESet ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to reset.
Description This command resets an error ratio measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example The following example resets an error ratio measurement addressed with
the measurement name identifier called ‘MyMeasurement’:
:PLUG:ERAT:RES ‘MyMeasurement’
:PLUGin:ERATio:STARt
Syntax :PLUGin:ERATio:STARt ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name to start.
Description This command starts an error ratio measurement addressed by the
measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.