302 Keysight M8070A Programming Guide
5 SCPI Command Reference
:PLUGin:ERATio:RUN:HISTory[:STATe][?]
Syntax :PLUGin:ERATio:RUN:HISTory[:STATe] ‘identifier’ <0|1|ON|OFF>
:PLUGin:ERATio:RUN:HISTory[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
Return Range 0|1|ON|OFF
Description This command enables/disables the storage of error ratio measurement
results addressed by the measurement name identifier.
This query returns the current setting.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example The following example enables storage of error ratio measurement results
with the measurement name identifier called ‘MyMeasurement’:
:PLUG:ERAT:RUN:HIST ‘MyMeasurement’, 1
:PLUGin:ERATio:RUN:HISTory:CLEar
Syntax :PLUGin:ERATio:RUN:HISTory:CLEar ‘identifier’
Input
Parameters
‘identifier’: Specify the measurement name.
Description This command deletes the storage of error ratio measurement history
addressed by the measurement name identifier.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8046A.
Example The following example deletes error ratio measurement history with the
measurement name identifier called ‘MyMeasurement’:
:PLUGin:ERATio:RUN:HISTory:CLEar ‘MyMeasurement’
To Next Page
Loading...
